DragLab / Guides / How to measure your CdA
GuideHow to measure your CdA: the methods compared
From wind tunnels to an outdoor ride with a power meter, there are several ways to find your drag area. Here's what each does well, what it misses, and how to get a good result.
For one exact number, a wind tunnel or a careful outdoor test with a power meter. For comparing positions often and cheaply, a 3D scan or back-to-back outdoor runs on the same day. The best plan uses more than one.
The methods at a glance
| Method | What it measures | Good for | Watch out for |
|---|---|---|---|
| Wind tunnel | The real force of air on you, pedalling | The most precise single number; testing kit | Cost and travel; a short session |
| Velodrome test | CdA from power and speed on an indoor track | Repeatable, no wind | Track hire; needs a good power meter |
| Outdoor field test | CdA from a ride file with power, speed and height | Free; your real kit on real roads | Wind, traffic, tyre and power-meter errors |
| Aero sensors | Air speed on the bike, live | Feedback while riding | Cost; calibration rides |
| 3D scan (DragLab) | Your frontal area, then CdA from it | Comparing positions at home, as often as you like | Estimates the drag coefficient; legs still |
| Computer simulation (CFD) | Air flowing over a 3D model | Seeing where drag comes from | Only as good as the model and set-up |
Outdoor field testing, step by step
An outdoor test uses the physics of your ride: the power you put in has to equal the power that went into air, tyres, climbing and speeding up. With enough steady riding, the CdA that makes the sums add up is yours. It's sometimes called the virtual elevation or Chung method.
- Pick a course. A quiet loop of a few kilometres, or a straight road you can ride out and back. No junctions, no stopping, and ideally no big hills.
- Pick a calm day. Wind is the biggest source of error. Early mornings are often calmest.
- Prepare the bike. Zero (calibrate) your power meter before you start, and use the same tyre pressures every time.
- Ride steadily in one position for the whole test: no braking, no freewheeling, no drafting. Several laps beat one.
- Record a .fit file with power, speed and GPS, then analyse it. DragLab can measure your CdA from it.
- Repeat it. Two or three tests on different days show how consistent your number is.
The inputs matter more than the maths.
Assuming your tyres roll a little easier than they do, or a power meter that reads 2% high, can each shift your CdA by a few percent. Keep everything the same between tests and the differences between positions stay trustworthy, even if the exact number is slightly off.
Comparing two positions outdoors
The most reliable way is to swap between them on the same ride: lap one in position A, lap two in position B, then A, then B. Same day, same tyres, same power meter, so nearly every error cancels out.
3D scanning: what it can and can't tell you
A 3D scan measures your shape precisely: how much of you faces the wind, and where. DragLab builds a 3D model of you on your bike with your iPhone's LiDAR camera, takes out the turbo trainer and tidies the wheels, then measures your frontal area.
To turn area into CdA, it needs a drag coefficient, which depends on how air flows round you. DragLab uses a typical figure for your riding position, and once you've measured your CdA from a ride, your own. So:
- Comparing your positions is where scanning shines: quick, at home, as often as you like.
- A single CdA from a scan alone is an estimate. A ride file makes it yours.
- It can't see fabric, or how your legs change drag through the pedal stroke.
Measure yours with DragLab
Scan your position with your iPhone and see your frontal area, your CdA and the watts the air costs you, then what to change.